Over the last two decades technology for turning the sun’s energy towards electrical energy has developed very fast, and as a result lots of people have decided to give it a go.

The real benefit of creating your own solar panels is that the homeowner will learn how to repair and maintain them when damage occurs. Solar Panels Perth This is a big advantage when it is considered that solar power lends itself quite naturally to isolated locations. They are quite lightweight to transport, apart from the batteries used for storage, and the mounting of the panels before operation doesn’t require special equipment or electrical knowledge.

There is no question that the simplest way is to just reach out to a specialist to do the whole installation. In the spirit of utilizing go greene technology, creating homemade solar panels is worth the effort – but be cautioned there are some pitfalls to avoid

Most of these materials are easily accessible, but the range of cells may confuse the beginner. To start out with, photo-voltaic cells are the simplest to worth with and are inexpensive. Avoid using those that are wax dipped or ‘b’ grade, because the end result will not meet the output expected.

In addition, some supplies from countries such as China have been substandard and unreliable in delivery. The actual construction process for homemade solar panels is to assemble all the equipment and materials in a dry and dust free space.

When it comes to building your own solar panels the tools required are: a hammer, saw soldering iron, screw drivers and a paintbrush. These are the necessary tools that exist in the workshop of the average DIY enthusiast.

The materials list includes some timber to make the frame for mounting the panels on the roof. Screws and wood panels to make the housing for the cells, and black paint are required also in the construction of homemade solar panels.

Obtain photo-voltaic cells and the tab wiring to connect them, selecting pre-tabbed cells to make the project less boring and faster.

Find some eva glue, solder and flux, plastic sheeting to cover the lid of the housing as well as blocking diodes to stop current reversal and the project can be started.

Create an housing and seal it with some silicone filler. Spread the cells out on a backing board and glue them in a arrangement of 6×6 with the tabs facing up. Connect the tabs in series with solder and tab wiring adding the diodes to stop current reversal when the unit is not receiving enough sunshine.